Polyeco? PV waterproofing membrane
Scope of application
Scope of application: widely used in industrial and civil building roof waterproofing engineering, recommended products for photovoltaic energy single-layer roof waterproofing system.Product specifications
Model |
Thickness(mm) |
Wide(m) |
Length(m) |
Lap edges |
Execution standards |
H-type (average material) |
1.5、1.8 |
2.0 |
20 |
weld |
GB27789-2011 |
Type P (fabric reinforced) |
1.5、1.8、2.0 |
Product specification
1.Selected brand polymer raw materials, and improvedweather-proof formulas;
2.Excellent physical properties, and resistance totensile & tear and wind uplift;
4.Extremely high light reflectivity (design value > 87%);UV resistance; effects in reducing room temperature and power consumption; mitigate urban heat islandeffect;
Technical indicators
Executive standard: GB27789-2011 "Thermoplastic polyolefin (TPO) waterproofing membrane"Serial number | project | index | |||
---|---|---|---|---|---|
H | P | ||||
1 | The thickness of the resin layer on the intermediate tire base/mm≥ | - | 0.40 | ||
2 | Tensile properties | Maximum pull/(N/cm) ≥ | - | 250 | |
Tensile strength/MPa ≥ | 12.0 | - | |||
Elongation at maximum pull/% ≥ | - | 15 | |||
Elongation at break/% ≥ | 500 | - | |||
3 | Low temperature bending | -40°C without cracks | |||
4 | Seam peel strength/(N/mm) ≥ | 4.0 or coil destruction | 3.0 | ||
5 | Right angle tear strength/(N/mm) ≥ | 60 | - | ||
6 | Artificial climate accelerates aging | Time/h | More than 5000 | ||
Appearance | No blistering, cracks, delamination, bonding and holes | ||||
Maximum pull retention/%≥ | - | 90 | |||
Tensile strength retention/%≥ | 90 | - | |||
Elongation retention at maximum pull/%≥ | - | 90 | |||
Elongation at break retention/%≥ | 90 | - | |||
Low temperature bending | -40°C without cracks |